NSC9700 Introduction Scope of application: Suitable for road, rail tunnels, bridges and culverts, squares, buildings and other for flood lighting use. NSC9700 performance characteristics, anti-glare function: selection of nano photocatalyst glass, automatic decomposition of surface stains, keep the light effect; selection and protection of diffuse angle design can effectively prevent glare. Effective in reducing the stimulation of the construction workers of eyes avoid discomfort and fatigue. , The luminous efficiency energy-saving: use a special gas discharge lamp as the light source, high luminous efficiency, long life; dual-tube HPS lamps without cooling can be initiated immediately and re-start. 3, for the environment: the use of high-strength alloy material, has strong anti-impact and impact strength capacity; multi-channel vibration structure and surface spraying, high-frequency vibration in the workshop, roadbed, track and humid, high temperature environment in the long-term stability Working. 4 Installation: wall-mounted and ceiling-mounted and other installation, illumination angle in accordance with the up and down within 25 ° be adjusted. According to the scene adaptation φ10 ~ 4mm diameter cable, and enabling more light and even use for the layout of lighting projects. Electronic, mechanical dual protection device, after opening the cover automatically cut off the power supply, use and maintenance more secure and reliable. NSC9700 technical parameters Rated voltage: 220 V Light Source: HPS gas discharge light flux 400W: 52000lm average life: 50000h Luminous flux 250W: 27500lm Average life: 50000h MH gas discharge the 400W light flux: 38000lm Average life: 20000h Luminous flux 250W: 23000lm Average life: 20000h Dimensions: length × width × height 515 × 402 × 198mm Weight: 15kg NSC9700 Note 1, transportation lamps mounted on the carton with, and add the foam cushioning. 2, when used, the surface of the light of a certain temperature, which is a normal phenomenon; Transparency center temperature higher, not touch. 3, replace the lamp, you should use the same type of power of the bulb; If you change the bulb type or power should replace the corresponding supporting ballast. Will NSC9700 use, according to the site environment and lighting needs to determine the location and manner of installation of lighting, its fixed installation; lamps the distance to the 220V power supply contacts to prepare for the appropriate length of φ6 ~ 8mm cable. 2, pressing his hand to the the lamp lower end of the two lid release button, opened a light front cover, will be ready to one end of the cable through the introduction of the compression nut of the device to the introduction of the lamp cavity, in accordance with the polarity of the wiring seat indicated, FireWire " L "side, the zero line" N "end of the ground wire to the ground terminal, and then the introduction of the device tighten the compression nut. 3 Close the front cover, and then cable the other end connected to 220V power lighting. Replace the lamp, push the lower end of the lamp two lid release button, opened lamps front cover, wring out the bad bulb and replace it with the same model new lamp tighten, then fasten the front cover firmly.