NFC9176 suitable for a variety of indoor and outdoor workplaces. Railway tunnels, factories, workshops, site, corridor, channel and cabins and other indoor and outdoor play areas for flood lighting. NFC9176 performance characteristics using the new induction lamp as the light source, cold start and hot start can be instantaneous; average service life of 80,000 hours, 10 times more than ordinary fluorescent lamps, no need to replace the light source in the life of those products; 2 light source high efficiency, low power consumption, good color rendering, power factor> 0.95, no flicker, no glare, which can effectively avoid the staff eye discomfort and fatigue, improve work efficiency; lamp body is made of high strength aluminum alloy materials and high-tech surface treatment, transparent parts made of imported bulletproof plastic material, high transmittance, impact resistance, rust resistant, can be used in harsh environments and long-term; lamps and electrical boxes for one design, the volume small, light weight, compact structure, beautiful, simple and smooth appearance; 5. embedded, ceiling and other installation, to meet the different needs of ambient lighting. The NFC9176 Technical parameters Rated voltage: AC/DC220V 50Hz Enclosure protection: IP65 Insulation class: corrosion level I: WF2 Inlet thread: G3 / 4 drop cables: ?8 ~ 14mm Dimensions: φ230 × 183mm Weight: 2.2Kg 1, According to the scene and lighting needs, determine the location and manner of installation of lighting, distance to AC220V power contacts press lamps, ready corresponding length the ?8 ~~ 14 mm three-core cable; 2, open the lock on the side of the lamps, unscrew lamps cover the compression nut of the cable into the mouth, one end of the cable through the compression nut is introduced into the inside the lamp (the introduction to the lamps inside the cable length of about 35 to 40mm for the best), and the ignition wire (red), and line (black), ground wire (yellow-green) relative to be connected to terminals L, N, G end, and then tighten the compression nut and fasten the lamp lock; 3, according to the determined installation lamps fixed installation Well, then the other end of the cable connected to the mains, lighting can be achieved. Note, transportation lamps mounted on the carton with, and add the foam cushioning. 2, when used, the surface of the light of a certain temperature, which is a normal phenomenon. 3, before replacing the lamp, be sure to cut off the power. 4, the luminaire is suitable for mounting height of 2 to 4.5 meters, maximum projection range Ф7 of meters. If the external flexible cable or cord of this luminaire is damaged, the line should be replaced by the manufacturer or its service agent or a qualified person.